Geothermal Earth Loops for Mitchell

In part three of our Introduction to Geothermal series, we are going to discuss geothermal loop systems and how each type works.

A geothermal loop is the series of underground pipes used to move heat to and from the earth. The pipes are made out of high-density polyethylene to establish a dependable, long-lasting system. They are fastened together by the process of thermal fusion that will develop a bond that is far stronger than the original pipe itself. In fact, a properly installed loop can remain up to 200 years.
 
There are two leading types of geothermal loop systems that are almost always used in today's installations: open loop systems and closed loop systems. Both systems have different pros and cons for your heating or cooling solution. We at Affordable Geothermal LLC have the training and expertise on both types, and we will help you by determining the right choice for your geothermal installation.

Open loop geothermal solutions are designed to maximize the natural groundwater from beneath your home. Using a well, water is from an existing aquifer and moved to the geothermal heat pump where its heat is extracted and the water is pumped back into the ground or to an assigned runoff. Since the water that you are handling is not being altered in any way, the only thing that is being returned to the earth is water that is slightly warmer or cooler (depending whether you're in heating or cooling mode).

One thing to keep in mind with an open loop system is water quality. Mineral build-up can arise from poor quality water. This can be attended to with an occasional cleaning. If the water in the ground has greater iron content, you may want to make sure that the discharge water is prevented from coming in contact with air before it is returned in order to prevent clogs.
 
Closed loops are just as they sound. Rather than pumping water from a well and depositing it elsewhere, water is circulated in a entirely sealed circuit with a small amount of eco-friendly antifreeze.
 
There are two primary types of closed loop installations: horizontal and vertical. Installing the system horizontally requires quite a bit of land space. The piping is embedded in trenches between 4 and 6 feet deep and can be up to 400 feet long. If you reside on a smaller lot, the loops can be installed vertically by boring straight down using drilling equipment. This kind of installation can be installed in as little as a 10ft by 10ft  area.
 
In either case, the larger the building, the larger the geothermal heat pump and loop needs to be. A good ball park figure is that for every ton of system capacity, you will need 500 to 600 feet of pipe.
 
Contact Affordable Geothermal LLC today to learn more about what system choices are available to you here in Mitchell.